Thingiverse
Roller Shade Pull
von Fordmender
0
Downloads
1
Likes
0
Makes
Simple shade pull for standard roller shade. Made to slip over bottom bar.
This is a snug fit on the shade, but you can still center on the shade easily.
If it's too snug, you can scale it to your liking.
Depending on how you layout the model, you may need supports on the Shade Pull.stl.
Version two is designed so that you will not need supports at all.
This is a snug fit on the shade, but you can still center on the shade easily.
If it's too snug, you can scale it to your liking.
Depending on how you layout the model, you may need supports on the Shade Pull.stl.
Version two is designed so that you will not need supports at all.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!