Rolling Ducksie

Print in Place rolling ducksie! The cute little duck from kthuen whose neck will bob up and down via wheel mechanism inside as it's rolled across a surface (real smooth surfaces probably wont work though). It's also a decent calibration print because of the wild overhangs, steep curves, small details, and moving parts. There is a built in support tab on the bottom and along the neck where the head starts that needs to be removed. I also added a raft, given the little material that touches the bed, so it doesnt break free during print. Ssome support material on the sides of the neck was also needed since I noticed without it the head will move a little during print and cause the beak to print sloppy. If you need more bed adhesion try increasing the raft size. Should also be scalable, but I haven't tried anything above 100% yet. Post Print:First just pull the support tab off the bottom and clean up the wheel where it was connected so the wheel is nice and round. Then you should be able t