MakerWorld
Other Toys & Games
Ver Modelo
Rolling Pool Cue Bridge
73
Descargas
36
Likes
35
Makes
ASSEMBLY INSTRUCTIONS:Print the main body in TPUPrint the Wheels in PLA (using a sharp tool, the supports should come out of the wheel pretty easily)Cut the steel rod (linked below) into 2" piecesUse the locking washers (also linked below) to connect the wheels onto the body. (I tend to print an extra wheel, and use it to hold the washer, allowing me to just tap the rod into it without losing the small washer pieces. It also stops the rod from going too far through the washer) NEEDED EXTRAS:https://amzn.to/3I2uO1W (Steel rods)https://amzn.to/3I0v7dp (Locking washers) Boost Me
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
