Thingiverse
Rotating cable holder
von GinSICILY
45
Downloads
47
Likes
0
Makes
I created this " rotating cable holder " (with 3 slot), because the smartphone charging cables and earbuds were always messy. In addition to being an ideal design object on the desk, it is very useful to keep everything in order.
I printed all the parts with level height 2.5 and 10% infill.
Except for small parts.
Only these parts need the supports : door, valve, upper cover.
The parts go to interlocking, just note , be very careful to the small pins on the top of the middle part because in making the force you can break,
but they are not essential , just glue the part and it works the same.
Good press and like it.
I printed all the parts with level height 2.5 and 10% infill.
Except for small parts.
Only these parts need the supports : door, valve, upper cover.
The parts go to interlocking, just note , be very careful to the small pins on the top of the middle part because in making the force you can break,
but they are not essential , just glue the part and it works the same.
Good press and like it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
