Rotating Labyrinth

The Rotating Labyrinth is a map created by James Eck, and published as part of a module for TTRPG gaming! The map features many interlocked rotating circles, this model attempts to do the original justice. Each piece can have a magnet embedded in the bottom in order to allow it to snap align in the correct position, securing it in place.

Map and module can be found at: https://www.drivethrurpg.com/product/209116/Rotating-Labyrinth

Instructions:
Using your preferred slicer, print one of each part.
If your printer is dual color capable, feel free to configure a color change 2-3 layers below the map layer, and again right after for a cool pre-colored map!

Magnets used were 2x1mm for most points, and 4x2mm for the points holding C1 to the base. While they are not required, they do help to snap the parts into place when rotating, and keeping the whole piece together!

A small amount of post processing was required on my printer, but it isn't tuned well, so you may experience le