Slicer Discord
Roundabout – 3D-printbaar model van GrabCAD GrabCAD
SOLIDWORKS

Roundabout

144 Downloads
10 Likes
0 Makes
Model downloaden
For this project, instead of your typical round of the bout intersection, I created a roundabout (pun intended). This roundabout is supposed to symbolize the end of an interstate, splitting into a transitional street (Trent Blvd.) and a state road (#82, Indigo Ave.). State Road 82, otherwise named as Indigo Ave., is split into East and West for a simpler way of understanding where the driver is going. Whilst the roundabout is two lanes wide, if a driver is turning left, they're assumed to be in the left lane (except for Trent Blvd.. (A sign containing the description of the roundabout was meant to be made, but I ran out of time). The bike lanes are colored blue, with bike lane signs to symbolize their existence. In order to increase the safety of the bikers, a curb separating the main road to the bike lane was created. In order to cross over State Road 82, Hawk signal traffic lights were created to help cross. As for the walking pedestrians, a bridge for the sidewalk was created. The bridge has a cross section through the middle of the roundabout, and leads pedestrians to either the top of a parking garage, or a ramp to the ground on all sides of the roundabout.
Categorie
SOLIDWORKS
Bron
GrabCAD
Gepubliceerd
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STEP, STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie