Routine Tracker

I designed this flip-up tracker for my daughter to manage her morning routine. Print-in-place hinges make this a single piece. The flaps flip up with a satisfying magnetic stick to check off each task. We mounted it on the wall with some double-sided tape.The slots are designed for 38 x 38 mm pictures (1.5 x 1.5 inches) which my wife found on Etsy. Any paper or print should work. A thin 3D-printed card could also work.There are hexagonal cavities for 6 x 2 mm round/disk magnets and a pause in the print profile. (I tried hexagonal holes to snuggly fit the round magnets while still allowing some tolerance - it worked.) This version requires two magnets per flap, 12 magnets total. I am sure smaller magnets could also be used in the same cavities. Your mileage may vary and/or it may require some glue to keep them in place before they are printed over. 2025-11 Update: added a print profile for the 4 Task version (fits the A1 mini). Same modules, just 4 of them. :) Requires 8 magnets.