Thingiverse
RovNav Case
von Paulvp
2
Downloads
5
Likes
0
Makes
RovNav Case is designed to hold Navio2 with Raspberry Pi 3A+, Pi Cam v1.3 and GNSS antenna with the fasteners already available with Navio2 (no additional fasteners required) as a single portable unit for prototype development, Rover and other educational purposes. Cable tie is used to restraint the GNSS antenna (optional - its kind of secure already). The top frame holding the camera and the GNSS antenna is simply press fit on the top cover (without fasteners).
POST-PROCESSING NOTE:
Incase camera doesn't fit properly due to hole posts misalignment in the case, try using the be-burring tool on the posts. Else, simply remove 1-2 posts that is causing this misalignment. The camera will be still fixed properly.
De-burring tool is useful to shave away edges that cause tolerance issues. A drill bit of next suitable size without drilling machine (its too fast - melts plastic) to manually spin with hand is helpful for holes cleaning. However, handle delicately for your safety (eyes
POST-PROCESSING NOTE:
Incase camera doesn't fit properly due to hole posts misalignment in the case, try using the be-burring tool on the posts. Else, simply remove 1-2 posts that is causing this misalignment. The camera will be still fixed properly.
De-burring tool is useful to shave away edges that cause tolerance issues. A drill bit of next suitable size without drilling machine (its too fast - melts plastic) to manually spin with hand is helpful for holes cleaning. However, handle delicately for your safety (eyes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
