Thingiverse
RPi Fan Mount
door RedWhere2020
4
Downloads
5
Likes
0
Makes
A very simple 40mm fan mount for the Raspberry Pi.
You will need standoffs to mount to the RPi itself. I used 18mm high standoffs.
Obviously using 5v fans you can power it off the RPI 5v/Gnd GPIO pins.
I printed it with Esun ABS+, 4 walls, 5 layers top & bottom and 100% infill.
Takes about 25min to print.
It shrinks a little using ABS+ and the fan holes became a little tight to mount the fan but it does fit.
Worked for me.
You will need standoffs to mount to the RPi itself. I used 18mm high standoffs.
Obviously using 5v fans you can power it off the RPI 5v/Gnd GPIO pins.
I printed it with Esun ABS+, 4 walls, 5 layers top & bottom and 100% infill.
Takes about 25min to print.
It shrinks a little using ABS+ and the fan holes became a little tight to mount the fan but it does fit.
Worked for me.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
