Thingiverse
RPI Zero Flirc Case HD Camera Module
door hnrk
22
Downloads
6
Likes
0
Makes
A Raspberry Pi HD camera module for the Flirc Raspberry Pi Zero Case.
First time using Fusion 360 and my printer is a bit wonky but hopefully it still works for others.
In addition to the screws included with the case you'll need two M2.5x8mm screws and two M2.5x10mm screws as well as four m2.5 nuts.
You'll need to print 4 2mm distances to place between the hd camera module and the case lid.
Be careful but bend the ribbon cable properly where it connects to the rpi zero. Otherwise the whole port might snap off the board when the lid is screwed on. As it did for me. :
I'm using it together with the excellent [showmewebcam](https://github.com/showmewebcam/showmewebcam).
Depending on what mount you use, you might need a cable with a 90 degree bend. Turns out I didn't leave alot of space around the usb port with this design.
First time using Fusion 360 and my printer is a bit wonky but hopefully it still works for others.
In addition to the screws included with the case you'll need two M2.5x8mm screws and two M2.5x10mm screws as well as four m2.5 nuts.
You'll need to print 4 2mm distances to place between the hd camera module and the case lid.
Be careful but bend the ribbon cable properly where it connects to the rpi zero. Otherwise the whole port might snap off the board when the lid is screwed on. As it did for me. :
I'm using it together with the excellent [showmewebcam](https://github.com/showmewebcam/showmewebcam).
Depending on what mount you use, you might need a cable with a 90 degree bend. Turns out I didn't leave alot of space around the usb port with this design.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
