Ruler

Here's the story: I lost my ruler at school and knew I couldn't keep borrowing one from my teacher. (Well, I could, but I wanted my own ruler.) I went into Tinkercad and whipped up a ruler. I made a couple mistakes but I googled how to correct them once it was in Bambu Studio.⚠ Warning: This design is made for 0.2 & 0.4 mm Nozzles. Other Nozzles will not work with most print profiles. ⚠So with that, I was able to print my own ruler. I will make future updates to this print, and let me know your feedback in the comments. Every bit helps.Boost MeHey! Did you like this model? I know it's kind of basic, but every bit helps. Boosting this model can help me a lot. Thank you for your support!Things to take note of:With 0.4 Nozzles, the millimeter ticks may not stand out from each other. You will need to look closely for each tick. (Top Picture)With 0.4 Nozzles, the Metric side numbers 10 - 18 will cover the cm line. The cm line is at the end of the number (Bottom Picture): This ru