Thingiverse
RunCam Split2 Mount
von Bigtimeb
2
Downloads
0
Likes
0
Makes
4mm nozzle
.2mm layer height
This is for the RunCam Split 2. The original did not put the camera out far enough for a clear shot with no obstructions. The frame was in view, This is an Armattan Japalura 4" frame.
I also used uxcell M2x3mmx3.5mm Female Threaded Brass Knurled Insert Embedded Nuts.
.2mm layer height
This is for the RunCam Split 2. The original did not put the camera out far enough for a clear shot with no obstructions. The frame was in view, This is an Armattan Japalura 4" frame.
I also used uxcell M2x3mmx3.5mm Female Threaded Brass Knurled Insert Embedded Nuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
