Thingiverse
RunCam2 Case
di alexmac3
1
Download
1
Likes
0
Makes
Printable replacement for the RunCam2 case.
I went through many iterations tuning the snap fit geometry to both hold the camera well, yet also allow it to release relatively easily. I decided to leave out the thumb tab release as I found it to be awkward and difficult to access, just push the camera out firmly and it will release.
Also included is a GoPro mount adapter that snaps into the case. This allows you to mount the RunCam2 to any GoPro compatible mount/accessory. This part is a remix of xxDvDxx's design.
The case prints well in PETG, 100% infill, no supports. It would probably work ok in PLA but the release might be a bit stiff.
I went through many iterations tuning the snap fit geometry to both hold the camera well, yet also allow it to release relatively easily. I decided to leave out the thumb tab release as I found it to be awkward and difficult to access, just push the camera out firmly and it will release.
Also included is a GoPro mount adapter that snaps into the case. This allows you to mount the RunCam2 to any GoPro compatible mount/accessory. This part is a remix of xxDvDxx's design.
The case prints well in PETG, 100% infill, no supports. It would probably work ok in PLA but the release might be a bit stiff.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!