Thingiverse
Runout Switch Bracket
von buildchimp
16
Downloads
11
Likes
0
Makes
This runout sensor is designed to work with the instructions I found here:
https://youtu.be/ijAuX8d3Mr4
CAUTION: I haven't tried hooking it up yet!
The limit switch I'm using is this one:
http://a.co/heXEf3J
This design is based on caliper measurements taken from the limit switch itself. Differences in hardware used on the boards may mean you have to modify the OpenSCAD file to fit!
https://youtu.be/ijAuX8d3Mr4
CAUTION: I haven't tried hooking it up yet!
The limit switch I'm using is this one:
http://a.co/heXEf3J
This design is based on caliper measurements taken from the limit switch itself. Differences in hardware used on the boards may mean you have to modify the OpenSCAD file to fit!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
