Rust Logo Stand

Made some adjustments to ThattCatto's design. Slimmed down the dimmensions, and drew a new base with "pre-drilled" holes in all pieces for assembly with screws. The base is the longest piece at 209mm (should be printable on smaller beds too if oriented 45 degrees) The letters and logo is 8mm deeep, base is 4mm thick. (See overall dimmensions on the photo)

I printed it fast in PLA, at 0.32 resolution, with 12% infill on a Crealty Ender-3 v2.

The screws used are 3mm countersink wood screws, 15mm long. Alternatively just assemble it together with some drops of superglue.