Ryobi Switch Mount

This is the switch mount for the Ryobi drill holder I posted earlier. This uses the original switch that comes inside the drill. You must de solder it from the board, then attach wires (minimum 18 AWG, Thinner wire would not let the drill turn on) I went with 18 AWG 3 feet long. Works well. This model uses M3x5x5 nut inserts (X2) along with M3x12mm screws (X2). I did have to ream the mounting holes slightly on the switch. They were a little tight on the M3 screws. The mount snaps onto the handle bar of the Lee classic press (½" Bar). A small dap of super glue to hold in place. Position where it is most comfortable. 2" down from the ball end worked for me. .2mm Height100% infillPETGNo supportsRaft (not needed, I like to use them)