Thingiverse
SABLE-USB Case
von mizyeh
5
Downloads
2
Likes
0
Makes
This a case for SABLE-USB which is Sable-2015's usb controller
1.put and screw three leg on if you want to hang it on the machine.
2.( IMPORTANT!) remove fiber board below cricut board.
3.put circuit board into the case with default copper pillars attached and screw it from back.
4.put on the case (don't hurt yourself , maybe round pattern next time) and you are good to go
1.put and screw three leg on if you want to hang it on the machine.
2.( IMPORTANT!) remove fiber board below cricut board.
3.put circuit board into the case with default copper pillars attached and screw it from back.
4.put on the case (don't hurt yourself , maybe round pattern next time) and you are good to go
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!