Thingiverse
SABLE-USB Case
door mizyeh
5
Downloads
2
Likes
0
Makes
This a case for SABLE-USB which is Sable-2015's usb controller
1.put and screw three leg on if you want to hang it on the machine.
2.( IMPORTANT!) remove fiber board below cricut board.
3.put circuit board into the case with default copper pillars attached and screw it from back.
4.put on the case (don't hurt yourself , maybe round pattern next time) and you are good to go
1.put and screw three leg on if you want to hang it on the machine.
2.( IMPORTANT!) remove fiber board below cricut board.
3.put circuit board into the case with default copper pillars attached and screw it from back.
4.put on the case (don't hurt yourself , maybe round pattern next time) and you are good to go
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!