Sand Casting Flask Holder

Simple end caps & stand for 100mm sand casting flask I would still put a clamp or something around the whole thing to stop it falling apart as you poor, but that's up to you. makes pouring much easier, I will be casting these in Brass.

Holder will need resizing to fit your flask

Just got around to finally sizing & making full flask holder, had to make twice to get it too right size, not bang on but close enough

X = 110.38mm
Y = 123.00mm
Z = 111.00mm

This I will be casting in Brass too when I get around to it, nice n heavy.

Good luck with it