Thingiverse
Scranner
door Wings20667
13
Downloads
7
Likes
0
Makes
I made this to undo hard to reach screws. The fit is tight and the bit needs persuading into the hole but atleast it doesnt fall out.
Takes a standard 1/4 inch screwdriver bit.
Ive tested it holding the handle in a vice and twisting the bit with mole grips and it takes alot to make the bit spin in place.
Takes a standard 1/4 inch screwdriver bit.
Ive tested it holding the handle in a vice and twisting the bit with mole grips and it takes alot to make the bit spin in place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!