Thingiverse
Scream Firework Launch Pad
von Mattew_var
4
Downloads
1
Likes
0
Makes
A little basic 3 component printable stand to hold your firework. It was designed with a 5mm hole on it to fit the basic scream rocket, but of course you can scale it up with the same ratio.
On the photos the darkened parts are burned from the first few rocket tests.
On the photos the darkened parts are burned from the first few rocket tests.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
