Screen-mounted mouse cable bungee

19/6/23: Modified base mount with a hole to optionally fit a second cable clip on the back. This allow to fix a set length of cable to always be available for movements, preventing for example the cable available to get too short by slipping behind the desk. Also added an extra short 19mm pin option.

I modified the mouse bungee with a few improvements. I thought the mount was unnecessarily big, so I made it smaller and use less unnecessary material, also to be less conspicuous. I changed the locking system to push pins to achieve a tighter fit with nearly no wobble (any wobble left comes from the ball bearings themselves and can't really be eliminated other than by adding a second set of bearings.)
I also added a set of cable clips to accomodate for different diameters of mouse cables out there. ranges from 2.5 to 4mm diameters. Your printer might make these holes bigger on smaller so don't rely on the cable measurement too much. Easiest way would be to print them all and see which