Thingiverse
Screen Stand
por steve-walsh18
5
Descargas
9
Likes
0
Makes
Simple screen stand. I designed it for my portable computer monitor but should work on some tablets.
You will need to print two (one for each side) and although untested, there is also a 1 cm riser to raise the height if needed and you can print as many of these as needed to achieve the desired height.
Printed with 20% infill but if want stand to be heavier, increase as necessary.
Supports are needed for the connections but they were a bit of a pain to remove. This could have been an issue with my settings as I am very new to 3D printing.
You will need to print two (one for each side) and although untested, there is also a 1 cm riser to raise the height if needed and you can print as many of these as needed to achieve the desired height.
Printed with 20% infill but if want stand to be heavier, increase as necessary.
Supports are needed for the connections but they were a bit of a pain to remove. This could have been an issue with my settings as I am very new to 3D printing.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
