Thingiverse
Screw Camera Mount bracket
by rcw88
0
Downloads
0
Likes
0
Makes
Based on morganlowe's brilliant Frame Edge Camera mounting device, this one, https://www.thingiverse.com/thing:3223228 , this is a variation of the frame edge mount, beefed up a bit in Tinkercad, so its not as pretty.
Made to accept a real screw, you'll need to thread the hole - drill out to 3.3mm for an M4 bolt or try tapping at M3.5 without - the tapping size for M3.5 is 2.9mm..
BTW that photo is about ten times full size, so its warts an all!
Made to accept a real screw, you'll need to thread the hole - drill out to 3.3mm for an M4 bolt or try tapping at M3.5 without - the tapping size for M3.5 is 2.9mm..
BTW that photo is about ten times full size, so its warts an all!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!