Thingiverse
Screw Camera Mount bracket
door rcw88
0
Downloads
0
Likes
0
Makes
Based on morganlowe's brilliant Frame Edge Camera mounting device, this one, https://www.thingiverse.com/thing:3223228 , this is a variation of the frame edge mount, beefed up a bit in Tinkercad, so its not as pretty.
Made to accept a real screw, you'll need to thread the hole - drill out to 3.3mm for an M4 bolt or try tapping at M3.5 without - the tapping size for M3.5 is 2.9mm..
BTW that photo is about ten times full size, so its warts an all!
Made to accept a real screw, you'll need to thread the hole - drill out to 3.3mm for an M4 bolt or try tapping at M3.5 without - the tapping size for M3.5 is 2.9mm..
BTW that photo is about ten times full size, so its warts an all!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!