Thingiverse
Screw Cap for filament guide
von brainberry_net
0
Downloads
1
Likes
0
Makes
I have all my filament over my printers so I needed a save way to get it into the feeder (especially on my ultimaker where it has to come from bottom).
So I made this little guides...
With safety pin.
Not round for faster printing.
So I made this little guides...
With safety pin.
Not round for faster printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
