Thingiverse
Screw Thread Checker
von CharlesM479
128
Downloads
84
Likes
0
Makes
I made this for FRC Robotics teams. These are the most common screws we use on our robots.
Make 2 fill them both with nuts. Then take one and put screws in from the bottom. Then you have one to check screws and one to check nuts.
When I used a 0.6 nozzel the text would not come out good. 0.4 worked great. Sharpie for the text.
Make 2 fill them both with nuts. Then take one and put screws in from the bottom. Then you have one to check screws and one to check nuts.
When I used a 0.6 nozzel the text would not come out good. 0.4 worked great. Sharpie for the text.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!