Thingiverse

Screwdriver Case

von dbcoop

12 Downloads

7 Likes

0 Makes

Bought some ceramic screw drivers off Amazon and quickly realized that they souldn't last long in a tool box so I designed a Case specifically for them. I decided to go with TPU for the base because I could make the cut out for the end of the screwdriver handle just a tad too small and it would grip the screw driver and prevent them from coming out. You dont have to do the same the lid should hold them in but they will quickly fall out once it is open and that just seemed like and irritation. If you do pint in PLA or ABS I suggest you scale up a couple of percent so that there aren't clearance issues with the section I intentionally made .25mm to small.

adjustment case ceramic conductive electronics screwdriver screwdriver case screwdriver holder adjustment case ceramic conductive electronics screwdriver screwdriver case screwdriver holder

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat