SD and Micro SD Card Holder
door ambulancedriver2
16
Downloads
13
Likes
0
Makes
A simple 6 slot SD and 6 Slot Micro SD card holder based on the original by DuDlik. I needed more slots for both card types, and didn't want to print multiple holders.
UPDATED:
I found an error in the bottom half of this print. One of my dimensions was off by 1 mm. It has been updated to v2, and v1 deleted. I also widened the slots for the micro SD cards by .25 mm to make them fit slightly better. The outside of the top half of the box is intentionally slightly smaller to give you a little bit of a lip to grab the bottom half by if your print is slightly tight.
UPDATED:
I found an error in the bottom half of this print. One of my dimensions was off by 1 mm. It has been updated to v2, and v1 deleted. I also widened the slots for the micro SD cards by .25 mm to make them fit slightly better. The outside of the top half of the box is intentionally slightly smaller to give you a little bit of a lip to grab the bottom half by if your print is slightly tight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
