MakerWorld
Other Hobby & DIY
Zum Modell
sd and micro sd case
2
Downloads
1
Likes
0
Makes
The details are printed separately, it is important to make sure that there are no plastic flows on the lock between the lid and the base, then connect them by locking the lock, this happens with a little effort, install the magnets in the tray and the base and use!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
