Thingiverse
SD card WiFi adapter
by willfly
253
Downloads
201
Likes
2
Makes
Tired of ejecting the SD card from 3d Printer for adding new gcode - this adapter makes it WiFi enabled, i.e. you can remotely upload the gcode from your computer to the SD card.
This module based on ESP8266 reads/writes to SD card, and also leaves the SD card interface open to reading from 3d printer.
It works well with the RAMBO board and Marlin firmware in my printer, but should work in any setup that uses a SD card. A *Toshiba Flash Air SD* card which is commercially available, will do this as well, in case you want to save the trouble of soldering and programming chips.
**Details:**
My printer uses "RepRap full graphic LCD controller" and supports printing from a SD card. I replaced the SD card with this module - which is a blank fullsize SD card adapter, ESP8266 and a microSD card. See the wiring diagram.
The ESP8266 runs a WebDAV server which is the protocol for accessing networked drives and supported by Windows and other operating systems. This server can be acce
This module based on ESP8266 reads/writes to SD card, and also leaves the SD card interface open to reading from 3d printer.
It works well with the RAMBO board and Marlin firmware in my printer, but should work in any setup that uses a SD card. A *Toshiba Flash Air SD* card which is commercially available, will do this as well, in case you want to save the trouble of soldering and programming chips.
**Details:**
My printer uses "RepRap full graphic LCD controller" and supports printing from a SD card. I replaced the SD card with this module - which is a blank fullsize SD card adapter, ESP8266 and a microSD card. See the wiring diagram.
The ESP8266 runs a WebDAV server which is the protocol for accessing networked drives and supported by Windows and other operating systems. This server can be acce
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
