Thingiverse
SD Gecko PCB version
by DNKROZEKJ
3
Downloads
6
Likes
0
Makes
A remix of the DIY SD Card reader for Gamecube by [Dragort](https://www.thingiverse.com/Dragort)
I've changed the design to fit a complete PCB from a generic SD Gecko adapter since my original one was broken.
The holders on the lid have been extended also to avoid bends and hold the PCB tighter.
Tabs on the lid have been adjusted to allow a nicer fit an avoid sanding.
SD opening has been adjusted to be as flushed as possible with the PCB and case.
Added two slots on the front laterals to mimic the original slots from an standard Gamecube card, this allows a nicer fit and doesn't stress out the locking mechanism in the memory card port.
Feel free to change and remix my design if needed.
Since this is my fist time using Fusion 360 some n00b mistakes are most probably going to be present, you've been warned ;)
I've changed the design to fit a complete PCB from a generic SD Gecko adapter since my original one was broken.
The holders on the lid have been extended also to avoid bends and hold the PCB tighter.
Tabs on the lid have been adjusted to allow a nicer fit an avoid sanding.
SD opening has been adjusted to be as flushed as possible with the PCB and case.
Added two slots on the front laterals to mimic the original slots from an standard Gamecube card, this allows a nicer fit and doesn't stress out the locking mechanism in the memory card port.
Feel free to change and remix my design if needed.
Since this is my fist time using Fusion 360 some n00b mistakes are most probably going to be present, you've been warned ;)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!