Security Drone

So I'm building a new drone using a Navio 2 and Raspberry Pi 3, that's about 480 mm in diameter. This can be either fully printed, or cut using carbon fiber, G10, other various plates.

Navio 2 Case: https://www.thingiverse.com/thing:3251955
Sled for Zephyr V2: https://www.thingiverse.com/thing:3301160
GrabCAD: https://grabcad.com/library/zephyr-v2-1

Non-printed parts you'll need:

2x 300 mm carbon fiber tubes, 16 mm outer diameter
2x 100 mm carbon fiber tubes, 16 mm outer diameter
2x 200 mm carbon fiber tubes, 8 mm outer diameter
4x 7 mm outer diameter vibration shock absorbers
Screws/Nuts/Spacers

24x M3 20 mm (for Arms)
16x M3 6mm (securing motors to Motor Mounts)
8x M3 8 mm (for Motor Mounts)
8x M3 25 mm (for Leg-Clamp/Foot/motor mount through 16mm tube)
6x M3 12 mm (for GPS and Antenna mounts)
4x M3 30 mm (for Arm-Holds)
4x M4 40 mm (H-Frames)
4x M4 10 mm (for Leg-Clamp to Bottom-Plate)
2x M3 metal/plastic nuts (Need these INSIDE the Foot pieces)
34x M3 nyl