Thingiverse
Self-similar balancing objects
door nicnacs
23
Downloads
27
Likes
1
Makes
This is just a curious set of objects I designed which can balance on each other in a rather extended way.
Note that you must print it out at 100% infill. Even so, it should only be about 60 grams of plastic. I recommend a brim, because on my printer, the skinny arms would tend to peel up from the print bed during printing otherwise.
Note that you must print it out at 100% infill. Even so, it should only be about 60 grams of plastic. I recommend a brim, because on my printer, the skinny arms would tend to peel up from the print bed during printing otherwise.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
