Slicer Discord
Semi-Automatic Crossbow – Modello 3D stampabile da Thingiverse Thingiverse

Semi-Automatic Crossbow

45 Download
38 Likes
0 Makes
Vai al Modello
I was a little underwhelmed with the miniature weapon selection on the site, so I spent a couple of hours working on this. Load the magazine up to ten shots, and it will fire one after another.
Tips:
Assemble with computer hard drive screws (you know, the smaller threaded ones)

Holes, for the most part, are all 10mm apart, very easy to make further attachments.

I really don't know why I have to explain it to everyone I hand this thing to, but here's how you fire it (properly).

1) Pinch your fingers around the firing pin
2) Pull the pin back quickly as to allow only a single pellet to enter the chamber. Doing this slowly (like scared you're gunna break it slowly) will sometimes either cause it to jam, or for some of the pellets to fall out.
3) You don't have to but to get the most powerful shot, pull the pin as far back as you can without it falling out of the chamber. (no really, someone pulled it back just enough for the pellet to load, and then complained that the shot
Fonte
Thingiverse
Cosa serve per stampare: Intermedio Bassa affidabilità
Perché?
supporti necessari
Pezzo unico Supporti richiesti Viteria richiesta
Supporti 2/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 1/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA
Post-elaborazione
Viteria
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione