Thingiverse

Sensor Housing

von Kickbut101

8 Downloads

2 Likes

0 Makes

[On PrusaPrinters](https://www.prusaprinters.org/prints/137432)

Housing for my BRUH inspired Temperature/Humidity/Motion sensor backed by an ESP8266 (NodeMCU) controller. Designed to fasten together with M3 bolts/screws

Thingiverse now only lets you post 500KB sized photos...? So heres an imgur album to help understand the build
https://imgur.com/a/eHFrXjB

BOM:
- M3 Screws
- AM312 Infrared PIR Motion Sensor Pyroelectric Module Detector For Arduino 3-5m (Ebay)
- NodeMCU ESP8266 ESP-12 WiFi Development Board Module ESP 8266 ESP8266MOD (Ebay)
- W-Unlimited 1PC Universal AC DC Power Adapter USB Port Wall Charger (Ebay)
- DHT11 Temperature Humidity Sensor Module Digital Single Bus 3.3V-5V, Humidity Measure Range 20%-95% Temperature Measure Range 0-50℃ w (Amazon)

I made about 10 of these sensors and revised the print each time until I got it real nice. This is that outcome.

Note: I did rip the pre-soldered pins off the DHT sensor so that it would nestle nicely in the bot

anti humidity box bruh EMotionTech ESP8266 hanger hass home assistant Homeassistant humidity sensor motion sensor nodemcu NodeMCU ESP8266 temperature sensor temperature enclosure temperatur sensor anti humidity box bruh EMotionTech ESP8266 hanger hass home assistant Homeassistant humidity sensor motion sensor nodemcu NodeMCU ESP8266 temperature sensor temperature enclosure temperatur sensor

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat