Serving jig Bowstring

Layer height 0.3 if you want it fast. 0.2mm otherwise.
I recommend infill 100%.
No supports needed

You will need:
- M6x70mm and nut (or 80mm M6 threaded rod with nut and nylon nut)
- L59mmxD4.2mm rods. 3 pieces. Just edit the freecad file if you need another diameter.
- Glue, to glue the rods permanently.

Tools:
- Drill bit of around 1mm to drill the hole of the thread.

Notes:
- Print with recommended settings.
- Glue the squared 'bodyCover' after puting the 3 rods
- You can also glue the nut to the turning wheel if you want.
- This will fit a spool with a diameter hole of 10mm and length of 49mm