Thingiverse
Servo Mount
by AlexGale
507
Downloads
438
Likes
1
Makes
Mounts a Tower Pro 9 gram micro servo and a Fitec 9 gram continuous micro servo.
Two sheet-metal Phillips oval 4 x 3/4 screws secure the front of the servo to the mount (see picture above). For the back, use 4 x 3/8 screws[see footnote 1].
The mount gets secured to a base by three M3 * 5 mounting screws.
Recently, I added another design with two side attachments. The old one had one attachment.
[1]Also, some may see that the screws I recommended are too large in the front: the screw fits perfectly in the back, but where the hole is (in the front), the screw goes through the hole. Someone (in the comments) reccomended to use the screw size 4 x 3/8.
Two sheet-metal Phillips oval 4 x 3/4 screws secure the front of the servo to the mount (see picture above). For the back, use 4 x 3/8 screws[see footnote 1].
The mount gets secured to a base by three M3 * 5 mounting screws.
Recently, I added another design with two side attachments. The old one had one attachment.
[1]Also, some may see that the screws I recommended are too large in the front: the screw fits perfectly in the back, but where the hole is (in the front), the screw goes through the hole. Someone (in the comments) reccomended to use the screw size 4 x 3/8.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
