Thingiverse
Servo Simulator
door MegaCadler
23
Downloads
19
Likes
0
Makes
Sometimes it is hard to see what an RC receiver really outputs on each channel because programming of Transmitters and their Mixers sometimes is weird. Even more programming is different between various brands.
This Servo Simulator diplays the output of an RC receiver in microseconds, percentage and as graphical bars/servos.
The valid signal must be between 700-2300us, assuming 1000us=-100%, 1500us=0%, 2000us=+100%.
It uses an Arduino Nano to evaluate up to 8 RC signals and display them on a Nextion LCD. The power supply is a 2S Lipo via Voltage regulator. You can use other supplies but then the battery icon is not valid.
Connect the PWM outputs to 1-8 input channels.
CPPM and SBUS options will be added in future.
Click on the bars to change the colors of them.
Click on the servos to change the angle of a rudder horn.
Click on [nor]/[inv] to change the servo direction.
What you need besides the printed case and some screws:
- 1 Arduino Nano
- 1 Nextion Display NX4832T035
This Servo Simulator diplays the output of an RC receiver in microseconds, percentage and as graphical bars/servos.
The valid signal must be between 700-2300us, assuming 1000us=-100%, 1500us=0%, 2000us=+100%.
It uses an Arduino Nano to evaluate up to 8 RC signals and display them on a Nextion LCD. The power supply is a 2S Lipo via Voltage regulator. You can use other supplies but then the battery icon is not valid.
Connect the PWM outputs to 1-8 input channels.
CPPM and SBUS options will be added in future.
Click on the bars to change the colors of them.
Click on the servos to change the angle of a rudder horn.
Click on [nor]/[inv] to change the servo direction.
What you need besides the printed case and some screws:
- 1 Arduino Nano
- 1 Nextion Display NX4832T035
MegaCadler publiceert ook op
42 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
