Thingiverse
seven segments display diffuser
door jgonnot
1
Downloads
0
Likes
0
Makes
I made this part, because I find the readability of this type of display not very good.
for four digit display.
tite fit, no glue needed on my test.
must be printed in vase mode, and the "extrusion width" must be set to 0.45mm.
otherwise, you can edit the openscad file and make a new stl.
printed in white PLA, but, maybe, any color can do the job.
I give you the Openscad source file, under GPLv3 license.
Share your modification and Good print !
for four digit display.
tite fit, no glue needed on my test.
must be printed in vase mode, and the "extrusion width" must be set to 0.45mm.
otherwise, you can edit the openscad file and make a new stl.
printed in white PLA, but, maybe, any color can do the job.
I give you the Openscad source file, under GPLv3 license.
Share your modification and Good print !
jgonnot publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
