Thingiverse
Replacement Parts
Go to Model
Shade pull
12
Downloads
16
Likes
0
Makes
This cord pull goes on the end of a window shade.
Thread the cord through the middle and tie a knot.
If you want you can use a very small washer above the knot.
Sand lightly.
If printed in ABS do an Acetone vapor bath, about 10-15 sec.
Paint or dip-coat to your preference.
If you CNC this then I'd suggest using Deskproto to set up multiples for cutting several at one time.
The inner core has two diameters (larger on the bottom to hold the knot and smaller on the top).
Designed in truSpace and printed on a Form1+ Resin V2.
Art to part time: about 20-30 minutes.
Thread the cord through the middle and tie a knot.
If you want you can use a very small washer above the knot.
Sand lightly.
If printed in ABS do an Acetone vapor bath, about 10-15 sec.
Paint or dip-coat to your preference.
If you CNC this then I'd suggest using Deskproto to set up multiples for cutting several at one time.
The inner core has two diameters (larger on the bottom to hold the knot and smaller on the top).
Designed in truSpace and printed on a Form1+ Resin V2.
Art to part time: about 20-30 minutes.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
