Thingiverse
Animals
Zum Modell
SHARK
48
Downloads
44
Likes
1
Makes
SHARK what else to say its a cool shark
prints in 2 pieces and glued together. Easy to scale and no supports needed.
(Shark in Picture scaled to 130% with Cura)
I did not design the Shark I only cleaned it up and cut in half for easy printing.
Make sure the flat part is touching the Print bed, the tail imported to Cura appears to be flat but tilts in a slight angle.
In cura select the part, click on rotate and select "face to build plate" click on flat part of the shark and voilà!
prints in 2 pieces and glued together. Easy to scale and no supports needed.
(Shark in Picture scaled to 130% with Cura)
I did not design the Shark I only cleaned it up and cut in half for easy printing.
Make sure the flat part is touching the Print bed, the tail imported to Cura appears to be flat but tilts in a slight angle.
In cura select the part, click on rotate and select "face to build plate" click on flat part of the shark and voilà!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
