Thingiverse
Sheath for Push Dagger
von jackrammer
0
Downloads
0
Likes
0
Makes
Fits the "Between the Ribs" Push Dagger V1.0.1: Laffs Dynamics found here https://defcad.com/library/between-the-ribs-push-dagger/
Printed with 4 walls
.2 layer height
PLA+
20% infill
Recommend printing vertically. Still may require one tree support.
Retention on the blade will be tight immediately after print. Work the blade in and out of the sheath a few times and it will loosen to the point where the extruded thumb press surface allows for one handed removal.
Printed with 4 walls
.2 layer height
PLA+
20% infill
Recommend printing vertically. Still may require one tree support.
Retention on the blade will be tight immediately after print. Work the blade in and out of the sheath a few times and it will loosen to the point where the extruded thumb press surface allows for one handed removal.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!