Thingiverse
shelf bracket
von deanosid
31
Downloads
30
Likes
0
Makes
100mm x 100mm shelf bracket with twisted bar gusset.
I would say that if you print this item print with the hole side vertical as this will give the greatest layer strength with it been 90° to the load plane
I would say that if you print this item print with the hole side vertical as this will give the greatest layer strength with it been 90° to the load plane
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!