Thingiverse

Shelf Bracket

von Fresh_Dumbledore

2.2k Downloads

1.8k Likes

6 Makes

Zum Modell

This is a lightweight shelf bracket. It is designed for a 20 cm wide shelf and withstands medium loads.

PETG is recommended as a material for printing because of its slightly better mechanical properties. With a layer height of 0.2 mm, printing takes approx. 3.5 hours.

I hope you like it :)

Bookshelf optimization optimized shelf shelf bracket Shelf mount shelf support structure Topology Optimization Bookshelf optimization optimized shelf shelf bracket Shelf mount shelf support structure Topology Optimization Bookshelf optimization optimized shelf shelf bracket Shelf mount shelf support structure Topology Optimization

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PETG

Ca. Druckzeit

3.5 h

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Shelf Bracket

Ähnliche Modelle

Zur Sammlung hinzufügen