Thingiverse
Shelf Bracket
von rawkstar320
3k
Downloads
2.5k
Likes
21
Makes
I needed some shelves in my office, so I designed and printed some cool looking shelf brackets! This is a 3" angle, meant to be used with (2) screws into your shelf and (1) screw into your wall. Use a board 6" deep or less. The picture shown is a 5" deep board, 24" wide. The strength of your shelf with depend mostly on your wall anchors. I recommend drilling into a stud OR using a 50lb wall anchor.
Good luck!
Good luck!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
