Shelf Brackets

Brackets for building a DIY shelf out of a 1x10 or similar shelf board. Designed for X1C print bed (256mm * 256mm).*please note the slicer modifiers to make the bracket/screw part much strongI wanted a shelf that could specifically hold my vintage gaming consoles, while also letting my 5 1/4" floppy disk storage boxes slide underneath. The available space on my desk was 24". The local home depot near me sells 24" long by 10" deep shelf boards for under $10.This is the largest bracket I could fit on an X1C print bed (256mm x 256mm). It is overkill at 175g per bracket. I used $10 rolls of eSun ABS I got on sale (10 for $10). I printed with the following settings (see photos):Material: eSun black ABSLayer height: 0.28mm draftInfill: 15% gyroid (Modified the “brackets” portion to print at 25% infill)*Perimeter walls: 2 (Modified the “brackets” portion to print at 5 walls)*Supports: NoBrim: Yes Yes Yes - as much as you can add - warpage is worse on large boxey prints like th