Thingiverse
Shield handle
door G_FPV
41
Downloads
37
Likes
0
Makes
Couldn't fine a 3D printer friendly shield handle for props, costume etc. This is sized for kids up 10, so if its for an adult or older child, simply scale as needed.
The item can be printed on its side or back without supports. I printed at 0.12mm layer height which gives a very clean finish. Its also been designed to have maximum contact area with shield to facilitate a best chance of good adhesion with glue, hot glue, etc
The item can be printed on its side or back without supports. I printed at 0.12mm layer height which gives a very clean finish. Its also been designed to have maximum contact area with shield to facilitate a best chance of good adhesion with glue, hot glue, etc
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
