Thingiverse
Shift_Lever_Lock_Cap
por abrodew
0
Descargas
0
Likes
0
Makes
Just designed this because I have it missing in my 2013 Kia Rio. I haven't got it from the first time so I had to test a few models and this one was almost perfect except that I had to cut two small pieces of wire tape and stick them on the very bottom in order to make the height flush with the gear panel. Hope that makes sense and somebody finds this helpful.
Hit me with any question!
Note: In the slicer application, rotate the model 180 degrees and add Brim of at least 10 lines in order to avoid using support.
Hit me with any question!
Note: In the slicer application, rotate the model 180 degrees and add Brim of at least 10 lines in order to avoid using support.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!