Thingiverse
Shower support bracket
von fsa
7
Downloads
2
Likes
0
Makes
Shower head bracket
You know what this little part is for, it holds the shower head in place.
This version has a 4mm hole in it.
Designed to fit on a 20mm tube.
Cone is between 20 mm to 24.5 mm.
Water tube should not exceed 15mm.
Designed to be printed easily, no hangouts.
If needed, source file from designspark mechanical is there to be edited.
You know what this little part is for, it holds the shower head in place.
This version has a 4mm hole in it.
Designed to fit on a 20mm tube.
Cone is between 20 mm to 24.5 mm.
Water tube should not exceed 15mm.
Designed to be printed easily, no hangouts.
If needed, source file from designspark mechanical is there to be edited.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
